Hey all.
Can anyone help with programming a subroutine/subprogram please ?
The program is Fanuc on Seimens 808D basic.
I have 2 datum points set up on the milling table G55 and G56
I will call the subprogram .....LABEL1
I know I must finish the subprogram with M17
I will position the cutter at the respective Datum points and call the subprogram. My problem is what is the command to call the subprogram ?
Also do I write the subprogram at the start of the main program ?
Thanks for any advice offered.
Dave.
Can anyone help with programming a subroutine/subprogram please ?
The program is Fanuc on Seimens 808D basic.
I have 2 datum points set up on the milling table G55 and G56
I will call the subprogram .....LABEL1
I know I must finish the subprogram with M17
I will position the cutter at the respective Datum points and call the subprogram. My problem is what is the command to call the subprogram ?
Also do I write the subprogram at the start of the main program ?
Thanks for any advice offered.
Dave.