What's new
What's new

hardinge superslant with gn fanuc 6tc control m code for bar feed air

cutco

Plastic
Joined
Jan 9, 2019
I am looking for someone who has connected a barfeed to a hardinge superslant lathe with gn6tc control using an m code to control the air to the bar feed.is there a way to add an m code to the control? the manual has reference to a m20
but it does not work.I am presently using the parts catcher
valve output for the air,but it takes a few seconds to work.
any suggestions would be appreciated.
 
I think it says in the manual
"the barfeed signal is internally decoded, but external drivers are not supplied for it"
 








 
Back
Top