LNS Barloader Pushing Against Stop vs Just Pushing
Close
Login to Your Account
Results 1 to 2 of 2
  1. #1
    Join Date
    Jan 2011
    Location
    Kansas
    Posts
    714
    Post Thanks / Like
    Likes (Given)
    42
    Likes (Received)
    57

    Default LNS Barloader Pushing Against Stop vs Just Pushing

    So last December on one of our new machines we put a lightly used LNS Servo 80 S2 that the dealer had. I was used to the Quik Load models that were pnuematic, we have a couple of them, and with those we always push to a stop on the turret. This barloader has worked very well for the most part. Now we have a job that is extremely competitive and high volume. I would like to just have it push the bar out without bringing a stop block down. It always pushes it too far. I have the correct length programmed in the barloader control and the bar is tight against the push rod. don't believe it's coasting. I have talked to our apps guy and he says he just always uses a stop block because it's safer. We do have a servo bar loader 12 ft model on our Miyano machine and we use it without a stop all the time. Any ideas?

  2. #2
    Join Date
    Jan 2011
    Location
    Kansas
    Posts
    714
    Post Thanks / Like
    Likes (Given)
    42
    Likes (Received)
    57

    Default

    I'm going to answer my own question. I found a setting under application setup where you choose to use turret or not use turret. That solved the problem.

  3. Likes Ox, TeachMePlease liked this post

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •