Does anyone have a start up procedure for the Maho 800P.
A friend purchased a used Maho 800P from General Dynamics in Michigan back in 2010. This has the 40 National Tool Holder. He hooked it up in his shop and was able to manually control the machine (move the table, rotate the head, move the head up/down, etc). He never got around to learning how to program the computer, as the project he was planning to use this for was cancelled. So it has sat in his shop since then unused
He tried starting it recently and was not able to get the table to move (where he had moved it before). He does not have the manual for this machine and he could not recall what he did to get the machine to manually work.
Is there a start up procedure for this machine? Any thought on what the issue might be?
Dean
A friend purchased a used Maho 800P from General Dynamics in Michigan back in 2010. This has the 40 National Tool Holder. He hooked it up in his shop and was able to manually control the machine (move the table, rotate the head, move the head up/down, etc). He never got around to learning how to program the computer, as the project he was planning to use this for was cancelled. So it has sat in his shop since then unused
He tried starting it recently and was not able to get the table to move (where he had moved it before). He does not have the manual for this machine and he could not recall what he did to get the machine to manually work.
Is there a start up procedure for this machine? Any thought on what the issue might be?
Dean
