As long as you maintain the center height of the tool tip, yes. You will find tool shanks to be a bit on the hard side, so plan on a carbide endmill etc.
As long as you maintain the center height of the tool tip, yes. You will find tool shanks to be a bit on the hard side, so plan on a carbide endmill etc.
Yeah, like Dan (from Oakland) said, just make sure you remove material from the right side of your tool holder to maintain insert center height. Likewise, you can shim a smaller holder to fit a larger slot as long as you put the shim on the proper side. Good luck!
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.