nealmanning530
Plastic
- Joined
- May 30, 2019
Hello, Matsuura RA1 VMC with a tool change issue. My problem is it will complete the cycle but then instead of stopping it will try to do it again. I will then get ERROR 410: ATC can't stop at home
followed by 445: sequence time over.I checked the proximity switches,fine. I looked at the stop bits page and I can see that the switches are sending a signal to the PLC.I am stumped on this one.The control is a yasnac mx3 and the year is a 1989.Thanks in advance for any help.
followed by 445: sequence time over.I checked the proximity switches,fine. I looked at the stop bits page and I can see that the switches are sending a signal to the PLC.I am stumped on this one.The control is a yasnac mx3 and the year is a 1989.Thanks in advance for any help.