Cole2534
Diamond
- Joined
- Sep 10, 2010
- Location
- Oklahoma City, OK
I need to create a .375" deep, .125"( +.01, - 00) slot in 304ss. It's a 16.5" diameter circle in the face of a tube sheet for seating filter elements. Unfortunately I can't turn the part, lathe is a smidge too small so it's going on the VMC.
Would you guys HEM this with an undersized tool, run it traditionally with an 1/8" rougher, or something else?
The job was priced with a traditional slow movin path in mind so if that's the best way Im covered but I feel like there's a more efficient method.
Thanks, Cole
Sent from my SM-G973U using Tapatalk
Would you guys HEM this with an undersized tool, run it traditionally with an 1/8" rougher, or something else?
The job was priced with a traditional slow movin path in mind so if that's the best way Im covered but I feel like there's a more efficient method.
Thanks, Cole
Sent from my SM-G973U using Tapatalk