William D Keith
Plastic
- Joined
- Aug 22, 2019
Hi everyone,
We recently purchased a new DMG MORI C.N.C. Lathe. We haven't yet purchased a C.A.M. system so we are still using G Code programming to get it up and running. We are having a problem within the G71 cycle. The tool nose radius in the offset table is .015. That program will run if you bypass the roughing cycle and will run the finish profile. Joshua Burlson from MORI has to leave so he can't help us out. Could someone please review this program and tell us where we are going wrong? Your help would be greatly appreciated. Thank you.
William
The alarm Code is P203, D command figure error.
%
O0200(SAMPLE PROGRAM)
G00G20G40G80G99
M05
G28U0
G0G90G53Z-10.
N1(ROUGH O.D. .015 TNR)
G0T0101
G97M3S1000
G28U0
G54
G0X.85Z.1
M08
G50S3000
G96S200
G71U.06R.003
G71P10Q20U.01W.003F.008
N10G0X-.032
G1Z0F.001
G03X.069Z-.029R.035
G1X.4852Z-1.2224
G03X.500Z-1.3083R.5
N20G1Z-1.5
G1X.850
G0Z.100
G28U0
G0G90G53Z-10.
M09
M30
%
We recently purchased a new DMG MORI C.N.C. Lathe. We haven't yet purchased a C.A.M. system so we are still using G Code programming to get it up and running. We are having a problem within the G71 cycle. The tool nose radius in the offset table is .015. That program will run if you bypass the roughing cycle and will run the finish profile. Joshua Burlson from MORI has to leave so he can't help us out. Could someone please review this program and tell us where we are going wrong? Your help would be greatly appreciated. Thank you.
William
The alarm Code is P203, D command figure error.
%
O0200(SAMPLE PROGRAM)
G00G20G40G80G99
M05
G28U0
G0G90G53Z-10.
N1(ROUGH O.D. .015 TNR)
G0T0101
G97M3S1000
G28U0
G54
G0X.85Z.1
M08
G50S3000
G96S200
G71U.06R.003
G71P10Q20U.01W.003F.008
N10G0X-.032
G1Z0F.001
G03X.069Z-.029R.035
G1X.4852Z-1.2224
G03X.500Z-1.3083R.5
N20G1Z-1.5
G1X.850
G0Z.100
G28U0
G0G90G53Z-10.
M09
M30
%