Houndogforever
Hot Rolled
- Joined
- Oct 20, 2015
- Location
- Boring
I will need to add an OD grooving system to my lathe.
I currently have a single top notch 3 series holder that is is fair condition.
I have maybe 8 threading inserts for that holder.
I have purchased a lay down threading setup.
SO ANYWAY, if you were to purchase a new OD grooving tool, for turning small clip grooves. .031 .047 .062 wide, square bottoms.
I see the on side style with three or four corners, they look pretty cool but I reckon they ain't cheap.
This is low production so cheap is important. Frosts my rice krispies paying $28 for an insert.
THanks for your opinions.
I currently have a single top notch 3 series holder that is is fair condition.
I have maybe 8 threading inserts for that holder.
I have purchased a lay down threading setup.
SO ANYWAY, if you were to purchase a new OD grooving tool, for turning small clip grooves. .031 .047 .062 wide, square bottoms.
I see the on side style with three or four corners, they look pretty cool but I reckon they ain't cheap.
This is low production so cheap is important. Frosts my rice krispies paying $28 for an insert.
THanks for your opinions.