What's new
What's new

Okuma Cadet-Mate v 4020 with OSP U10M Controller Z-Axis home!!

Paul @Amrosia

Plastic
Joined
Jun 17, 2019
All,
Okuma Cadet-Mate v 4020 with OSP U10M Controller Need Help Setting ATC Home position for the z_axis
Can anyone help? Had issues with ATC Magazine Advance/retract...Finally got to attempt tool change and spindle seemed to bottom out or bump (rather hard on the mag) when it went to home 1 position.
 
Select Parameter Mode and "Item" down to *NC Optional Parameter Bit* page. Set Number (No.) 16 Bit 7 to 1 to expand more parameters. "Item" down to *System Parameter* page. "Page" down to the *Home Position* screen. Place cursor on Home Position 1 for z-axis and set it to what you need. Home Position 2 should be the Z+ limit. Be sure to hit *Backup* after changing parameters.

If you have a 3 piece alignment tool I can send you a procedure to do this without guessing where Home Position 1 should be.

Daryl
 








 
Back
Top