graemeian
Plastic
- Joined
- Dec 24, 2010
- Location
- north carolina
Help. This morning my Okuma VMC started going squirrel-ly. At the following code...
G1 somewhere
X-0.7157 Y2.3788
G03 X-0.7269 Y2.3856 I-0.009 J-0.0022
I put these values in CAD and both points are on the circle but they will not work on the machine.
I get
2255 Alarm Arc calculation 3
I have ARC CHECK DATA = 8 [0.0001 in]
CIRCLE RADIUS R COMMAND ERROR CHECK AMOUNT = 2
I tested it on an online g-code simulator and it worked.
The code was generated by Fusion 360.
Sorry about the spelling in the title.
What is my problem?
I think I found it. It was changed from G17
G1 somewhere
X-0.7157 Y2.3788
G03 X-0.7269 Y2.3856 I-0.009 J-0.0022
I put these values in CAD and both points are on the circle but they will not work on the machine.
I get
2255 Alarm Arc calculation 3
I have ARC CHECK DATA = 8 [0.0001 in]
CIRCLE RADIUS R COMMAND ERROR CHECK AMOUNT = 2
I tested it on an online g-code simulator and it worked.
The code was generated by Fusion 360.
Sorry about the spelling in the title.
What is my problem?
I think I found it. It was changed from G17