Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
The machine is a Hyundai L2100SY with 8" and6" chucks. I'm needing to partoff and tranfer 1.375 hex bar, but don't have near enough clearance. Any ideas?
For solid material (not drilled or bored out in the center) I will leave the sub in home position and part off to X.050 or thereabouts, leaving the part hanging onto 0.050" of material, or as little as I can get away with.
Then I'll grab the workpiece with the sub, spin the sub at 200 RPM to twist off the workpiece, and continue business as usual.
The twistoff is important because the material is much weaker in torsion than in tension.
I like this idea....,but it does have a .500 diameter hole in it. Has anyone tried something like this with a machined hole in the bar?
Notice
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.