Fitting a 2" aluminum ground subplate (not anodized) to a 27" x 67" table on my VMC. The existing table top surface had lots of corrosion damage from a previous fixture/riser block setup that allowed wet steel chips to fester on the table for years at a time. I cleaned it off to the point it's flat and useful again, but there's still pockets of pitting and rust. I think I've cleaned and stoned to the extent I'm going to.
I'd like to not pull this subplate off for awhile. Maybe never.
Should I just stick with a wipe down of way oil? Anyone use a sealant in a situation like this? I feel like a sealant would have to be in spray form for the size of this .
Thanks!
I'd like to not pull this subplate off for awhile. Maybe never.
Should I just stick with a wipe down of way oil? Anyone use a sealant in a situation like this? I feel like a sealant would have to be in spray form for the size of this .
Thanks!