What's new
What's new

Programming dwell okuma osp5020l lathe

J.olsen356

Plastic
Joined
Feb 22, 2017
Im looking to program a dwell on the bottom of a groove does anyone know the modifyer for the g04 command on this controller i would assume it would look something like this

G1 x.801
G04 p4
G0 x.520

Any input would be greatly appreciated!
 
Im looking to program a dwell on the bottom of a groove does anyone know the modifyer for the g04 command on this controller i would assume it would look something like this

G1 x.801
G04 p4
G0 x.520

Any input would be greatly appreciated!
Hello J.olsen356,
A dwell is specified with an "F" address in conjunction with G04. The unit of command values is determined by the selected programming unit system. The maximum allowable length of a dwell period is 9999.99 seconds.

Regards,

Bill
 
Hello J.olsen356,
A dwell is specified with an "F" address in conjunction with G04. The unit of command values is determined by the selected programming unit system. The maximum allowable length of a dwell period is 9999.99 seconds.

Regards,

Bill

Correct! G04 Fxxxx is the format.
 








 
Back
Top