welderboyjk
Cast Iron
- Joined
- Nov 22, 2006
- Location
- south west michigan
Since I don't know I'm asking those who do.
Been doing some net searching about the Anilam 6400 control. Google doesn't come up with much besides some machines that do have it.
Is Anilam basically an orphan now or is there still some support out there? From what I find Heidenhain acquired them and dropped the Anilam controls.
Are Chevalier VMC's any good? Are the linear models ok? Since Chevalier is still around I would assume parts/service are still available. Is that correct?
Any tips or advice on either would be appreciated, thanks.
Been doing some net searching about the Anilam 6400 control. Google doesn't come up with much besides some machines that do have it.
Is Anilam basically an orphan now or is there still some support out there? From what I find Heidenhain acquired them and dropped the Anilam controls.
Are Chevalier VMC's any good? Are the linear models ok? Since Chevalier is still around I would assume parts/service are still available. Is that correct?
Any tips or advice on either would be appreciated, thanks.