Ox
Diamond
- Joined
- Aug 27, 2002
- Location
- Northwest Ohio
Trying to get the output to fire for my HP Coolant.
At first I ass_u_med that is was simply a keep relay change, but I have edited the keeps, and no change per this situation.
Physical button is there, but no cycle.
When I key in the M code - I git that it is not a good code.
I have searched, and I can find info on using M code to fire a macro, but not so much for I/O use.
Ladder is all there and the same as my other sister machine.
Somehow I need to git M10 to coincide (?) with R0421.2 and M11 @ R0421.2
Hmmm, maybe I should re state that?
M10 is already = R0421.2 in the ladder.
I just don't know what I need to doo to get to the finish line.
I have several M code outputs that are used for a POS gantry unload system that I could reporpoise if absolutely necessary, but I would much rather just git it right.
Fanuc 18T
-----------------------
Think Snow Eh!
Ox
At first I ass_u_med that is was simply a keep relay change, but I have edited the keeps, and no change per this situation.
Physical button is there, but no cycle.
When I key in the M code - I git that it is not a good code.
I have searched, and I can find info on using M code to fire a macro, but not so much for I/O use.
Ladder is all there and the same as my other sister machine.
Somehow I need to git M10 to coincide (?) with R0421.2 and M11 @ R0421.2
Hmmm, maybe I should re state that?
M10 is already = R0421.2 in the ladder.
I just don't know what I need to doo to get to the finish line.
I have several M code outputs that are used for a POS gantry unload system that I could reporpoise if absolutely necessary, but I would much rather just git it right.
Fanuc 18T
-----------------------
Think Snow Eh!
Ox