Kyle Smith
Stainless
- Joined
- Apr 25, 2008
- Location
- Helmer, Indiana, USA
Classic Control, Hass TM-2P, with Renishaw Probe.
When I tried to use probing cycles back to back I would get a "Probe Startup Failure". Through trial and error I added a dwell of 12 seconds between the cycles and this fixed the problem. I tried different dwell times and figured out 12 seconds was about the minimum. Once one of the yellow LEDs went out on the mounted receiver I had to wait an additional 5 seconds. Is this just the way it is or is there a setting or programming technique to avoid this issue?
(PROBE LOCATION OF BORE);
T10 M06;
G90 G17 G40 G80;
G54;
G00 X0 Y0 A-90;
G43 H10 Z-0.4;
G65 P9995 W54. A10. D0.9;
G04 P12.
#5241= #5221;
#5261= #5221;
G00 G90 Z3.
;
;
(PROBE LOCATION OF TANG);
T10 M06;
G90 G17 G40 G80;
G54;
G00 X0 Y1.97 A21.5;
G43 H10 Z-1.3;
G65 P9995 W58. A14. D0.8 H0.6;
G04 P12.
G00 G90 Z3.;
;
;
(ETC.)
When I tried to use probing cycles back to back I would get a "Probe Startup Failure". Through trial and error I added a dwell of 12 seconds between the cycles and this fixed the problem. I tried different dwell times and figured out 12 seconds was about the minimum. Once one of the yellow LEDs went out on the mounted receiver I had to wait an additional 5 seconds. Is this just the way it is or is there a setting or programming technique to avoid this issue?
(PROBE LOCATION OF BORE);
T10 M06;
G90 G17 G40 G80;
G54;
G00 X0 Y0 A-90;
G43 H10 Z-0.4;
G65 P9995 W54. A10. D0.9;
G04 P12.
#5241= #5221;
#5261= #5221;
G00 G90 Z3.
;
;
(PROBE LOCATION OF TANG);
T10 M06;
G90 G17 G40 G80;
G54;
G00 X0 Y1.97 A21.5;
G43 H10 Z-1.3;
G65 P9995 W58. A14. D0.8 H0.6;
G04 P12.
G00 G90 Z3.;
;
;
(ETC.)