vegard
Aluminum
- Joined
- Jan 28, 2006
- Location
- San Diego, CA
Hi,
I recently picked up an Enshu 650vx with Fanuc 15M control.
I am making parts on the machine, but I haven’t figured out how to rigid tap successfully yet. I am starting to think that I may have an issue with the machine, but wanted to check with you guys that my code is right before I bite the bullet and pay the $800 buy-in to get phone tech support from Enshu.
When I run this code, it goes to the retract plane and the spindle just turns slowly until I get alarm EX193. RIGIT TAP ALARM
Here is the code, does it look ok for a 15m?
G00 G17 G20 G40 G80 G90
G91 G28 Z0.
N1 T1
M06 (0.25 RIGHT-HANDED TAP)
(MAX - Z.1)
(MIN - Z-1.)
G00 G17 G90 G54 X0. Y0.
G43 H1 Z.1
M08
G94
S400
G98 G84.2 Z-1. R.1 F20.
G80
M09
M05
G91 G28 Z0.
G28 Y0.
G90
M30
Thank you
-vegard
I recently picked up an Enshu 650vx with Fanuc 15M control.
I am making parts on the machine, but I haven’t figured out how to rigid tap successfully yet. I am starting to think that I may have an issue with the machine, but wanted to check with you guys that my code is right before I bite the bullet and pay the $800 buy-in to get phone tech support from Enshu.
When I run this code, it goes to the retract plane and the spindle just turns slowly until I get alarm EX193. RIGIT TAP ALARM
Here is the code, does it look ok for a 15m?
G00 G17 G20 G40 G80 G90
G91 G28 Z0.
N1 T1
M06 (0.25 RIGHT-HANDED TAP)
(MAX - Z.1)
(MIN - Z-1.)
G00 G17 G90 G54 X0. Y0.
G43 H1 Z.1
M08
G94
S400
G98 G84.2 Z-1. R.1 F20.
G80
M09
M05
G91 G28 Z0.
G28 Y0.
G90
M30
Thank you
-vegard