I've got an old Kia KT15 with Yasnac LX3 control that I setup a RS232 communication with DNC4U when I first bought it. Once I had it figured out thing worked like a champ sending/receiving programs to and from the machine. I hadn't used it in awhile powered it up tried sending a program and nothing. I have went over everything I can think of and no luck. Everything else on the machine is fine.
I bought a simple plug in RS232 tool to check to see what was active on the cable wires and everything is pointing to the machine.
My question is there simple things to check? Fuses, relays, parameters, ect…?
I bought another cable and had it wired up the same way to see if the cable crapped out no change. I really don't want to get inside this old beast and start tinkering but I'm back to working on the machine constantly and finger punching in code is getting old.
Anyone else run into a similar scenario or have ideas?
Thanks guys.
I bought a simple plug in RS232 tool to check to see what was active on the cable wires and everything is pointing to the machine.
My question is there simple things to check? Fuses, relays, parameters, ect…?
I bought another cable and had it wired up the same way to see if the cable crapped out no change. I really don't want to get inside this old beast and start tinkering but I'm back to working on the machine constantly and finger punching in code is getting old.
Anyone else run into a similar scenario or have ideas?
Thanks guys.