GENERALDISARRAY
Hot Rolled
- Joined
- Jan 3, 2019
I am thinking of making a subplate to mount on the table of my Robodrill.
When I use my Chick vises I use some adapter bars since the t slot spacing does not line up with the vise. The sobplate would have a grid of tapped holes
Also I can only fit one on if the rotary is on there.
I saw Brotherfrank post a picture of a cantilever mount rotary, but it had a tombstone type fixture on it with a support. So the load was still mostly centralized on the table.
What are the thoughts about cantilevering a rotary off the end of a small machine table with an oversized subplate?
When I use my Chick vises I use some adapter bars since the t slot spacing does not line up with the vise. The sobplate would have a grid of tapped holes
Also I can only fit one on if the rotary is on there.
I saw Brotherfrank post a picture of a cantilever mount rotary, but it had a tombstone type fixture on it with a support. So the load was still mostly centralized on the table.
What are the thoughts about cantilevering a rotary off the end of a small machine table with an oversized subplate?
