GDO
Aluminum
- Joined
- Jan 2, 2013
- Location
- United States
There has been this little noise, sort of like a chirping sound that shows up around 1900 rpm in my brother speedio s700x1. I think it may have been from a small crash from spring this year that either went under the radar due to how rarely I am at low rpms or had compounded since then into a real issue.
It's a young machine with under 1k hours and I did not budget for 1: this, right now and 2: the price of the spindle replacement being double what I was told it would be
That being the case I'd like to look into repair, as brother only replaces the whole spindle. There are a few shops near me that do that sort of thing but I want to know if there is anything I should look out for.
"You need a shop that can promise _____" or "Don't pay less/more than ___"
I know this may seem like a bit of a newbie/hobbyist approach but times are very tough
Thanks in advance
It's a young machine with under 1k hours and I did not budget for 1: this, right now and 2: the price of the spindle replacement being double what I was told it would be
That being the case I'd like to look into repair, as brother only replaces the whole spindle. There are a few shops near me that do that sort of thing but I want to know if there is anything I should look out for.
"You need a shop that can promise _____" or "Don't pay less/more than ___"
I know this may seem like a bit of a newbie/hobbyist approach but times are very tough
Thanks in advance