Is likely that a new Steinmeyer ballscrew that I installed in my Fadal has under a tenth backlash at the center and both ends? It’s 16” of travel.
I went to enter backlash values and measured almost nothing with a good Brown and Sharpe Best Test .0001 indicator.
I didn’t use jog, in manual mode I moved the axis -.1 then +.I”
Not complaining , just wondering if I have an error in my process
I did zero the backlash values before I started
Thanks
Sent from my iPhone using Tapatalk Pro
I went to enter backlash values and measured almost nothing with a good Brown and Sharpe Best Test .0001 indicator.
I didn’t use jog, in manual mode I moved the axis -.1 then +.I”
Not complaining , just wondering if I have an error in my process
I did zero the backlash values before I started
Thanks
Sent from my iPhone using Tapatalk Pro