Nikolaiownz
Aluminum
- Joined
- Feb 10, 2018
Hello
I got a iemca tal 65 barfeeder that i have some problems with.
i will not run in auto (its like it needs a signal to start auto mode - it started and stopped periodically before in quit.)
the PLC has lights in the inputs but it has no lights in the outputs and does no start when i put it in auto mode.
the battery was trash so i changed it but that did nothing.
when the problem started it seemd like it was a lose connection but i have tryed to poke around for hours with no luck.
can the PLC be done and need replacement?7
The plc is a sysmac c20 omron
everything works manual but i think that runs on relays.
I got a iemca tal 65 barfeeder that i have some problems with.
i will not run in auto (its like it needs a signal to start auto mode - it started and stopped periodically before in quit.)
the PLC has lights in the inputs but it has no lights in the outputs and does no start when i put it in auto mode.
the battery was trash so i changed it but that did nothing.
when the problem started it seemd like it was a lose connection but i have tryed to poke around for hours with no luck.
can the PLC be done and need replacement?7
The plc is a sysmac c20 omron
everything works manual but i think that runs on relays.
