Hello!
We have a Kia 15 cnc lathe with a bar puller on it - today I had the fingers adjusted too tight for a 3/4 diameter bar - I fed onto (into) the bar stock at about 15 ipm. This threw out a "AL8 - z axis torque alarm" that I can't get rid of. The control is a Yasnac LX3. I went to the control panels and looked for a thrown breaker or popped fuse but could not find anything.
Any suggestions or experience with this?
Thanks,
SJR
We have a Kia 15 cnc lathe with a bar puller on it - today I had the fingers adjusted too tight for a 3/4 diameter bar - I fed onto (into) the bar stock at about 15 ipm. This threw out a "AL8 - z axis torque alarm" that I can't get rid of. The control is a Yasnac LX3. I went to the control panels and looked for a thrown breaker or popped fuse but could not find anything.
Any suggestions or experience with this?
Thanks,
SJR