claya
Cast Iron
- Joined
- Aug 6, 2006
- Location
- california
We need to do a minor ladder edit on our J300. I know how to do the edit, but cannot figure out how to save the edit after. When we re-boot the control the ladder is unchanged.
Does anyone have a ladder edit procedure specific to the J300 or I-80?
I have the yasnac PLC programming manual, but it glosses over the saving of the edit.
Sent from my SM-G975U using Tapatalk
Does anyone have a ladder edit procedure specific to the J300 or I-80?
I have the yasnac PLC programming manual, but it glosses over the saving of the edit.
Sent from my SM-G975U using Tapatalk