Hello all.
In search of any feedback on a Yasnac J300 on a new to me Kitamura. I have no history on it other than it's been sitting and batteries died and was supposed to just needed parameters loaded.
Control will not boot past pass 6 and shows system booting then goes to error screen. I have tried rotary switch in all positions, disconnected all drives and everything from I/0 boards that will still allow control to power on.
Talking to Yaskawa sounds like my only choice may be to send whole rack in. Didn't know if anyone has tried swapping out boards or if they all have software that needs to be flashed on them.
In search of any feedback on a Yasnac J300 on a new to me Kitamura. I have no history on it other than it's been sitting and batteries died and was supposed to just needed parameters loaded.
Control will not boot past pass 6 and shows system booting then goes to error screen. I have tried rotary switch in all positions, disconnected all drives and everything from I/0 boards that will still allow control to power on.
Talking to Yaskawa sounds like my only choice may be to send whole rack in. Didn't know if anyone has tried swapping out boards or if they all have software that needs to be flashed on them.