Hi, I'm new here.
So, I have a Yasnac LX1 with Error codes: 352: OL (Z) and 310: Servo Off. I have the reference manual and it mentions that error 352 is related to "Electronic thermal relay trip". This alarm indicates overload.
I have already proceed by checking the servo-unit (Z) into the servopack and everything looks fine. However, I can't localize the "Thermal relay of servo-motor (Z)" in the panels. Any ideas about this or what and where to check.
Thanks a lot for your cooperation.
Note: This error was intermittent time ago but since february, the CNC cannot run. It stops immediately.
So, I have a Yasnac LX1 with Error codes: 352: OL (Z) and 310: Servo Off. I have the reference manual and it mentions that error 352 is related to "Electronic thermal relay trip". This alarm indicates overload.
I have already proceed by checking the servo-unit (Z) into the servopack and everything looks fine. However, I can't localize the "Thermal relay of servo-motor (Z)" in the panels. Any ideas about this or what and where to check.
Thanks a lot for your cooperation.
Note: This error was intermittent time ago but since february, the CNC cannot run. It stops immediately.