I bought an old but awesome Matsuura MC-600V. Learning a lot but still a newbie. Read through entire manual and says it should have a minimum of 256k of memory. I downloaded than deleted all the programs except for one small 5 line home program. Under the program it says it has 31k memory left. I tried to upload a small simple pocketing with outside contour and chamfer program and got memory over run. The guy who had it before me ran a 4th axis on it (not sure if that matters).
Not sure if there are any 8000 or 9000 number programs, and not site where to look for them. I called yaskawa and he ran through a method to clear the memory but had to change some switches on , main pc board, followed by do exactly this or you will erase something else!!! Made me nervous, anyone have any advise.
Thanks so much in advance, noobie but learning
Fast!!
Dan
Not sure if there are any 8000 or 9000 number programs, and not site where to look for them. I called yaskawa and he ran through a method to clear the memory but had to change some switches on , main pc board, followed by do exactly this or you will erase something else!!! Made me nervous, anyone have any advise.
Thanks so much in advance, noobie but learning
Fast!!
Dan