mouldmaker-13
Plastic
- Joined
- May 2, 2020
Hello all. I have a Deckel FP5 NC which I have been working on with the help of a very knowledgeable Electronics guy by the name of Michael on this forum. I am very indebted to him for the hours he worked with me getting things worked out.
Initially the machine had various electronic faults and required quite a bit of investigation as to why it was not operating.
Any way long story short, the control is now working well, all axis jog correctly and machine homes well.
One thing that I cannot get operating is the spindle. I am not sure of the sequence for initiating that. Does this need to be done through a data input, or small pgm?
My other problem is that I need someone that would not mind helping me with some basic instructions for operating the Dialog 4 controller, eg basic pgm input, etc
Once I can get past the basics, It should be ok as I am familiar with CNC mills.
Much appreciated for any help you can offer.
Initially the machine had various electronic faults and required quite a bit of investigation as to why it was not operating.
Any way long story short, the control is now working well, all axis jog correctly and machine homes well.
One thing that I cannot get operating is the spindle. I am not sure of the sequence for initiating that. Does this need to be done through a data input, or small pgm?
My other problem is that I need someone that would not mind helping me with some basic instructions for operating the Dialog 4 controller, eg basic pgm input, etc
Once I can get past the basics, It should be ok as I am familiar with CNC mills.
Much appreciated for any help you can offer.