Printable View
Hi,
I can program EPROM's without any problem, I just need a little file for EPROM (27C256). One simple BIN file. It looks like, that this is the first EPROM with SW for machine to operate. And it MUST be 7.07 as shown on picture, 7.05 is no good, because I have all 4 BIN files necessary for SPS plate and I tried to start machine with 7.05, but without success.
EPROM versions should be written down on a paper glued to aluminium sheet on the right side of D11 box. I just looked, mine unfortunately is quite old, 4.25 for CNC and 4B15 for SPS.
Unfortunately i have also very old EPROM Versions.
CNC V4.274/B
SPS A4B092/93
"aluminium sheet on the right side of D11 box"
Attachment 264669
Hi Gloryrates500
Could you perhaps mail me the EPROM/GAL files that you've read from your machine? Would be a lot easier than to tear my D11 to pieces to dump every EPROM/GAL. I want a backup, just in case my machine breaks down sometimes in the future.
My mail [email protected]
Thanks a lot
That's a very, very good idea. Just do it ASAP.
Hi, Viran,
is there any chance to send me both files for EPROM's with yellow sticker, as shown on your pic? As I explained in another post, I bought new plate SPS, but it is no use, because there is old SW version. Maybe your files are better - I can see number 7 on sticker ?? I am looking for version 7.07. Files should have 32KB.
BR.
Hi everyone,
I got firmware version 7.07 for Dialog 11. Deckel FP4a Dialog 11 works again as it should do. So, I have .BIN files (32K) for eprom's on SPS plate version 5 and 7 - for 3 axes machine!
BR.
Is there a reader for the code or is it mostly in hex? I am looking to rebuild the mill with Linux CNC soon and would prefer to have some ladder layout instead of making my own code up from scratch and educated guesses.
I do have a complete pinout and labels for each pin.
Hi, Viran,
sorry, data is available only in HEX.
BR.
