toolnuts
Cast Iron
- Joined
- Sep 27, 2009
- Location
- washington
Hi all,
I have been looking at a FP4NC and I was wondering if the control
cabinet could be placed to the left side of the mill, with the cabinet
door opening to the left. Normally the cabinet is placed at the rear,
but this makes for a very deep footprint (136").
The cable conduit would be facing toward the rear of the machine.
Any thoughts or insights would be appreciated.
Stay safe all,
Paul
I have been looking at a FP4NC and I was wondering if the control
cabinet could be placed to the left side of the mill, with the cabinet
door opening to the left. Normally the cabinet is placed at the rear,
but this makes for a very deep footprint (136").
The cable conduit would be facing toward the rear of the machine.
Any thoughts or insights would be appreciated.
Stay safe all,
Paul