Hey y'all,
Is there a spec for what a T-slot nut for 12mm slots should look like? I'm about to make a batch, but I don't think I have a good sample to work from - nothing that looks original in any case.
I bought a 3/8" clamping kit, but the T-slot nuts seem a little anemic on the shoulder, and they seem quite rounded all over. I'm worried that I'll maim the underside of the T-slots if I gronk down on them at all.
I made some nuts with 10mm thread but those seem to fit a little too tight. Here's a picture of the 3/8" roundballs back-to-back with one of my fatsos:
Siggi
Is there a spec for what a T-slot nut for 12mm slots should look like? I'm about to make a batch, but I don't think I have a good sample to work from - nothing that looks original in any case.
I bought a 3/8" clamping kit, but the T-slot nuts seem a little anemic on the shoulder, and they seem quite rounded all over. I'm worried that I'll maim the underside of the T-slots if I gronk down on them at all.
I made some nuts with 10mm thread but those seem to fit a little too tight. Here's a picture of the 3/8" roundballs back-to-back with one of my fatsos:
Siggi