[email protected]
Plastic
- Joined
- Oct 3, 2002
- Location
- Phoenix, MD, USA
My machine is the 40 taper model and the part that supports the outer end of the horizontal milling arbors is wrong. The arm appears to be ok but the hanger for the center does not fit the dovetail well and the point is out of alignment. The hanger drops straight down and doesn't have the outward offset used for the 8 inch arbors shown in the operators manual. Any help? Trades maybe?
Also I would like to locate a supplier for those 220 volt 6 watt bulbs in the motor cabinet that shows which drive is engaged. I can live without them but with no support from Sylvania/Osram I'm about to give up.
Thanks Bill Bonta
Also I would like to locate a supplier for those 220 volt 6 watt bulbs in the motor cabinet that shows which drive is engaged. I can live without them but with no support from Sylvania/Osram I'm about to give up.
Thanks Bill Bonta
