I wonder if anybody on the forum knows how a Mikron WF1 or WF2 basic oiling system works for the table carriage assembly.
I have a machine with a single oiling point located on the left upper side of the main carriage unit looking from the front. I assume it's like the FP1 and there are internal passage ways for the oil to get to where it's needed.
Plan was to install a single shot oiling system. I have seen a factory installed system which had several oiling pipes attached to different carriage parts, including the lead screws and slideways which I would like to replicate.
Thanks Adrian.
I have a machine with a single oiling point located on the left upper side of the main carriage unit looking from the front. I assume it's like the FP1 and there are internal passage ways for the oil to get to where it's needed.
Plan was to install a single shot oiling system. I have seen a factory installed system which had several oiling pipes attached to different carriage parts, including the lead screws and slideways which I would like to replicate.
Thanks Adrian.