ballen
Diamond
- Joined
- Sep 25, 2011
- Location
- Garbsen, Germany
I'm making some cast iron laps, using a Deckel 6017 rotary table on my FP2. I have a question about the placement.
The table has knobs and controls underneath which lie below the place of the feet. So the only reasonable way to mount it on my FP2 is at the front of the horizontal table, like this:
That puts it quite far from the column and horizontal spindle. Is this what Deckel intended, or was there a different solution envisioned for the FP2, which puts the table closer to the column?
The table has knobs and controls underneath which lie below the place of the feet. So the only reasonable way to mount it on my FP2 is at the front of the horizontal table, like this:
That puts it quite far from the column and horizontal spindle. Is this what Deckel intended, or was there a different solution envisioned for the FP2, which puts the table closer to the column?