ome.machining
Aluminum
- Joined
- Nov 7, 2015
- Location
- Denmark, Europe.
Hi :-)
I'm new to this forum.
But I just got myself a Prvomajska ALG-100*milling machine, and this gave me some questions :-)
One of them are about the power feed.
Do I understand it has in two direction?
Up/down and table sideways?
From what I can see in the manual I found online, it should be possible to change these on the joystick.?
But I can only change feed in sideways, not up/down?
On the other side of coloum, there are a little mechanical switch, for hight feed stop.
If this are activated, I can set it to autofeed upwards, but not downwards?
What can be the problem? And where to look? :-)
Shouldn't it work on the large handle/joystick?
Hope you guys can help.
Warm regards
Rasmus
I'm new to this forum.
But I just got myself a Prvomajska ALG-100*milling machine, and this gave me some questions :-)
One of them are about the power feed.
Do I understand it has in two direction?
Up/down and table sideways?
From what I can see in the manual I found online, it should be possible to change these on the joystick.?
But I can only change feed in sideways, not up/down?
On the other side of coloum, there are a little mechanical switch, for hight feed stop.
If this are activated, I can set it to autofeed upwards, but not downwards?
What can be the problem? And where to look? :-)
Shouldn't it work on the large handle/joystick?
Hope you guys can help.
Warm regards
Rasmus