toolnuts
Cast Iron
- Joined
- Sep 27, 2009
- Location
- washington
Hi Guys,
I am looking at a FP3NC mill that uses pull studs, can
you use a pull stud on a NMTB40 tool holder, that will work?
Can you buy pull studs that are for that, or can I make
my own that will work.
Is there room in the FP3nc spindle for the 3/4" extension on
the NMTB40 tool holder?
Paul
I am looking at a FP3NC mill that uses pull studs, can
you use a pull stud on a NMTB40 tool holder, that will work?
Can you buy pull studs that are for that, or can I make
my own that will work.
Is there room in the FP3nc spindle for the 3/4" extension on
the NMTB40 tool holder?
Paul