Hi all
We have a Deckel FP4A with Contour 2, But we have a little problem with it:
When i shut down the machine, next time when i turn it back on i have to go to reference points on the X,Y and Z axis, otherwise i can't run a program.
But when i move all axis to reference, it tries to go to the reference points but it stay's just a little before the reference point (like 0.015mm) and it shuts down the control power, error code : 17 Geschwindigkeitsfehler Y-Achse (Speed fault Y-Axis)
Sometime also Geschwindigkeitsfehler X-Achse or Z-Achse.
So now i switch control power back on (green push button), and move the axis away from end switch,
Now i run the reference cycle again, now the machine switch off the control power at 0.010,
Now i repeat step above, en machine switches off at 0.005
Now i repeat it again, and machines is referenced.
The problem is with all the axis but sometimes 1 or 2 axis have no problem and the 3 axis is the problem.
I will upload a video in on Youtube quick.
I hope somebody can help me.
We have a Deckel FP4A with Contour 2, But we have a little problem with it:
When i shut down the machine, next time when i turn it back on i have to go to reference points on the X,Y and Z axis, otherwise i can't run a program.
But when i move all axis to reference, it tries to go to the reference points but it stay's just a little before the reference point (like 0.015mm) and it shuts down the control power, error code : 17 Geschwindigkeitsfehler Y-Achse (Speed fault Y-Axis)
Sometime also Geschwindigkeitsfehler X-Achse or Z-Achse.
So now i switch control power back on (green push button), and move the axis away from end switch,
Now i run the reference cycle again, now the machine switch off the control power at 0.010,
Now i repeat step above, en machine switches off at 0.005
Now i repeat it again, and machines is referenced.
The problem is with all the axis but sometimes 1 or 2 axis have no problem and the 3 axis is the problem.
I will upload a video in on Youtube quick.
I hope somebody can help me.