I just removed the "driver Blocks" on the ISO40 spindel of my Anene VHF 3.
I found out that 1 was mounted with an 1/4"(20/inch) bold, and the other with an M6 bold.
The M6 thread was ruined, and the 1/4" bold wend in without any problem.
Strange thing is that also both "driver blocks" are different. Sadly the 1/4" bold doesn't fit in the other block. And I asume these blocks are hardend, so drilling out the hole won't go.
Does anyone know what is original?
I think the 1/4" bold when I see how it goes into the hole. But on the other site I find an 1/4"bold strange on an sweedish machine.
I found out that 1 was mounted with an 1/4"(20/inch) bold, and the other with an M6 bold.
The M6 thread was ruined, and the 1/4" bold wend in without any problem.
Strange thing is that also both "driver blocks" are different. Sadly the 1/4" bold doesn't fit in the other block. And I asume these blocks are hardend, so drilling out the hole won't go.
Does anyone know what is original?
I think the 1/4" bold when I see how it goes into the hole. But on the other site I find an 1/4"bold strange on an sweedish machine.
Last edited: