toolnuts
Cast Iron
- Joined
- Sep 27, 2009
- Location
- washington
Hello all,
Are you getting cabin fever yet?
Would it be possible to use NMTB40 tooling on a FP4NC
by replacing the hydraulic pull stud sustem with a NMTB
draw bar, or is there not enough from at the top for
the NMTB draw bar neck?
If there is not enough room at the top could I cut off
the NMTB neck and insert a deckel pull stud?
I have loads of NMTB40 tooling for my current Gorton mill.
Paul
Are you getting cabin fever yet?
Would it be possible to use NMTB40 tooling on a FP4NC
by replacing the hydraulic pull stud sustem with a NMTB
draw bar, or is there not enough from at the top for
the NMTB draw bar neck?
If there is not enough room at the top could I cut off
the NMTB neck and insert a deckel pull stud?
I have loads of NMTB40 tooling for my current Gorton mill.
Paul