figured out that these come out from the bottom. a 5mm T-handle is used to loosen the center set screw then the collets can be easily unthreaded from the end of the draw bar.
Purchase a collet tool, makes it simple. Make sure you get the dimensions correct, it’s stamped on face of the collet. Most often if German pull stud then 83.5mm but double check.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.