What's new
What's new

DMG mori NLX2500 Automatic tool presetter

Latheguy77

Plastic
Joined
Aug 26, 2019
Any one figure out how to use the automatic touch off arm on a double OD tool holder. The pre loaded program (9106) will not let you touch off when the Y axis is not zero returned. I have made changes to the program so I'm able to touch off in Z but not X. I can get it to touch off in X but I get a tool breakage alarm. I'm able to touch off manually.
 
Are you able to cycle start? What issue do you get?

May need to change some parameters.

6549.4=0 should disable checking Y axis position for cylce start
6424.7=1 should disable checking Y axis position for presetter mode
 
Yes I'm able to cycle start. I tested a different OD tool not in a double tool holder by putting Y at .002. It touched off X bad by .008. The double holder is off in Y -.462. Not sure if there is some kind of math equation that needs to be done in the program.
 
Press hard key “SETTINGS”
Chose number 1.
Page down.
Should show an option for Y-axis.

I will check on Monday


Sent from my iPhone using Tapatalk
 








 
Back
Top