I try to restore (and retrofit linuxcnc) the old maho, cannot disassemble the gearbox for replacement of bearings.
There is a suspicion that the bushing (2) in which splined shaft (1) holder is pressed was turned inside main body (3) and block screws (4) which fix a splined shaft. It's possible?
It would be desirable to look at the drawing of this assembly.
There is a suspicion that the bushing (2) in which splined shaft (1) holder is pressed was turned inside main body (3) and block screws (4) which fix a splined shaft. It's possible?
It would be desirable to look at the drawing of this assembly.