Hi all,
I have an oversized tool that I'd like to manually load during a program. According to the manual, m66 is supposed to do this, but it gives an error. I ran the following test code:
The error I receive is P118 tool locked during m6/toolchange
Sadly the manual isn't incredibly clear about manual tool changes, or what the error code actually means.
Does anyone out there know how to do this?
Thanks in advance.
I have an oversized tool that I'd like to manually load during a program. According to the manual, m66 is supposed to do this, but it gives an error. I ran the following test code:
Code:
T13 m6
M01
T18 M66
M01
T13M6
M30
Sadly the manual isn't incredibly clear about manual tool changes, or what the error code actually means.
Does anyone out there know how to do this?
Thanks in advance.