What's new
What's new

Trouble touching off left handed turning tools on backside of probe

GSMachinist

Plastic
Joined
Jul 27, 2020
I have a Mori Duraturn 2050, and have been attempting to use left handed turning tools. The issue is when I touch off the tooling on the back side of probe there is about a .098" difference between the right hand turning tools, and left hand when called to Z0. I have gone into the parameters (5017) and attempted to offset the Z value for the backside (d face) of the probe. When I alter the numbers in the parameters for right hand tooling, and then touch off the tool the geometry changes. When I do the same for the Left hand tooling there is no change to the geometry when touched off again:confused:. Has anyone had this issue when attempting to use left hand turning tools? If so what was done to correct the issue? thanks!
 








 
Back
Top