GSMachinist
Plastic
- Joined
- Jul 27, 2020
I have a Mori Duraturn 2050, and have been attempting to use left handed turning tools. The issue is when I touch off the tooling on the back side of probe there is about a .098" difference between the right hand turning tools, and left hand when called to Z0. I have gone into the parameters (5017) and attempted to offset the Z value for the backside (d face) of the probe. When I alter the numbers in the parameters for right hand tooling, and then touch off the tool the geometry changes. When I do the same for the Left hand tooling there is no change to the geometry when touched off again. Has anyone had this issue when attempting to use left hand turning tools? If so what was done to correct the issue? thanks!