Mori MVJR with MX2 control.
1st problem; after months of working without any problems then sitting unused for 2 weeks I was unable to DNC to the control. I was able to send programs from the CNC control to the computer.
Checked continuity to wires, to CP07 board, all good.
Disconnected and reconnected the cables to the boards in hopes that it was a bad connection, now things are much worse.
If I start it with the number switch set to 0 or 1 the monitor never turns on, servo won't turn on.
If I start it with the number switch set to 3 message WORK OFF LINE (or something like that)
If I start it with the number switch set to 4 Monitor lights up and servo can turn on but the following errors are returned:
174 Memory
OT 4
OT X
OT Y
OT Z
The lower half of the control seems to not have power.
Cannot do anything.
The parameters are there but I can't edit them.
Not sure what to do next, Yaskawa parts and service are so expensive it would be easy to spend more than the machine is worth.
I would like to try regenerating the parameters but the notes I have for that must be incomplete, they don't seem to do anything now.
These are the notes I have, I think there is something missing, it was years ago last time I did that.
#7 Generator Push
RES, NEXT & ORG
Then
PRM, OFS& NC DATA CLEAR
#4 Load Push
RES, NEXT & WRT
Then
SYSTEM TOTAL DATA MAKE
1st problem; after months of working without any problems then sitting unused for 2 weeks I was unable to DNC to the control. I was able to send programs from the CNC control to the computer.
Checked continuity to wires, to CP07 board, all good.
Disconnected and reconnected the cables to the boards in hopes that it was a bad connection, now things are much worse.
If I start it with the number switch set to 0 or 1 the monitor never turns on, servo won't turn on.
If I start it with the number switch set to 3 message WORK OFF LINE (or something like that)
If I start it with the number switch set to 4 Monitor lights up and servo can turn on but the following errors are returned:
174 Memory
OT 4
OT X
OT Y
OT Z
The lower half of the control seems to not have power.
Cannot do anything.
The parameters are there but I can't edit them.
Not sure what to do next, Yaskawa parts and service are so expensive it would be easy to spend more than the machine is worth.
I would like to try regenerating the parameters but the notes I have for that must be incomplete, they don't seem to do anything now.
These are the notes I have, I think there is something missing, it was years ago last time I did that.
#7 Generator Push
RES, NEXT & ORG
Then
PRM, OFS& NC DATA CLEAR
#4 Load Push
RES, NEXT & WRT
Then
SYSTEM TOTAL DATA MAKE