drylakemachine
Hot Rolled
- Joined
- May 22, 2008
- Location
- elmirage ca
Hi, have no idea of an edm's capabilities. Need a wire tie hole ,3 places on the flat outside of a hex. Can it start hole on that angle ?
303 ss se 11/16 hex , .090 from edge hex point to the c/l of a .060 hole. So about 1/2 inch from start to finish. I have 900
pieces. So will this work?
Thanks jim
303 ss se 11/16 hex , .090 from edge hex point to the c/l of a .060 hole. So about 1/2 inch from start to finish. I have 900
pieces. So will this work?
Thanks jim