pilot001
Plastic
- Joined
- Dec 31, 2014
- Location
- Hungary (EU) Szekesfahervar
SOLVED issue......
Anyone had the same ....
My Agie Cut 200D in MODE 6 setting (spark generator M6) the machine is not "working"
all other modes are ok. 1 -2 i don't really use so i guess those are fine too...
MODES 3 / 4 / 5 work.
In M6 the machine doesn't see any "Td" since.... 1 .. it is not putting out any voltage
2 not sensing the voltage. Putting it back to M5 the Td jumps up to MAX (since not cutting anything )
I am guessing that it is not putting out voltage ... but will try to measure it.
Last edited: