What's new
What's new

Agie HMI control HELP!!!!!

TurboGuy

Plastic
Joined
Dec 9, 2015
I have 3 Agie machines. 2 of them are running the older millennium control and one of them is a newer machine with the HMI control. When I take the programs from the old machine and put them into the new machine I get errors. Tons of errors. Mostly they are "collision detection algorithm between line # and #" and "straight line segment inverted by the offset of the wire". I would say that these are the 2 that I get the most.

Has anyone else had any trouble swapping program from the older controls to the new controls??


Can anyone give me any explanation as to WHY this happens??? I'm looking for the actual cause so I can program differently so I don't get these errors. Are there any tips or tricks that I don't know about? I have only been doing this for about a year so my experience is limited.

thanks
 
Have you called GF directly. that machine has had several software updates to address some programming issues. Make sure machine SW is up to date!
 








 
Back
Top